Volvo IMA P2
Injector coding for diesel Volvo P2
Write injector correction codes (IMA/C2I) to the engine control module after replacing or swapping injectors.
All operations are done through the OBD-II port — no need to remove or open the ECU.
Built for auto electricians and repair shops.
Main features
Read injector codes
- Read codes of all five injectors
- Shows VIN and ECU identifiers
- ECU check before writing
- Completely free
Write injector codes
- Code new injectors after replacement
- Change the order when swapping injectors between cylinders
- Fast and safe process
- Payment from account balance
Vehicle binding
- ECU identifiers are read before writing
- Payment is valid only for that vehicle
- No way to spend a payment on the wrong ECU
- Protection against mistaken operations
Repeat operations
- Re-writing the same ECU is free
- Repeat window — 1 hour after payment
- Made a mistake in a code — fix it at no extra cost
- Operations are logged in your account
Key features of Volvo IMA P2
🔐 Why injectors need coding
- Each injector has a factory fuel-quantity correction code
- Without coding — rough idle, smoke, increased fuel consumption
- After repair/cleaning the code order must match the cylinders
⚡ Works over OBD-II
No ECU removal or disassembly — read and write through the diagnostic port.
Ignition in position II, engine off, battery voltage at least 12 V.
🛡️ Operation safety
Before writing, the app verifies the vehicle’s ECM/CEM identifiers.
The operation is bound to that specific ECU — a paid coding won’t run on a different car.
🔑 Account binding
The app is bound to your account and computer via the website.
When a new PC connects, the previous binding is revoked automatically — device management is in your account.
🔌 J2534 adapter compatibility
Any J2534 Pass-Thru adapter is supported:
- Volvo DiCE
- Scanmatic 2/3
- Mongoose
- Openport 2.0
- Topdon RLink X7
J2534 support lets you use existing equipment without buying expensive interfaces.
📋 Supported vehicles
💰 Pricing
Reading codes
- Completely free
- No limits on reads
- VIN, injector codes, ECU identifiers
Writing codes
- 22€ per operation — charged from balance
- One payment = one vehicle
- Repeat writes free for 1 hour
How it works
Step 1. Download and run the app
A standalone mini-app, no installation required.
Click “Connect account” and confirm the binding on the website.
Step 2. Connect the adapter
Plug the J2534 adapter into the OBD-II port, ignition in position II.
Engine off — a battery charger is recommended.
Step 3. Read current codes
The “Read” button shows VIN, injector codes and their cylinder order.
Step 4. Write new codes
Enter the codes printed on the new injectors and click “Write” —
the operation cost is charged from your balance, writing takes a couple of seconds.
Frequently asked questions
Get started with Volvo IMA P2
If you repair diesel Volvo P2 cars,
this tool replaces dealer-level injector coding — over OBD-II, in a couple of minutes next to the car.